Thingiverse
GeeTech i3 pro C y belt holder
by ospalh
7
Downloads
5
Likes
0
Makes
A trussed y axis belt holder to fix the print bed to the belt on GeeTech i3 pro C and similar printers.
This replaces the odd aluminium block where you had to punch holes into your belt, that then start to tear the belt apart.
With the gap between the belt ends this works with the original belt that was used with the old block.
You only need one belt holder and one nut holder. Use the test shapes to find the right width for the belt gap. The belt should fit snugly into the holder. For that,
This replaces the odd aluminium block where you had to punch holes into your belt, that then start to tear the belt apart.
With the gap between the belt ends this works with the original belt that was used with the old block.
You only need one belt holder and one nut holder. Use the test shapes to find the right width for the belt gap. The belt should fit snugly into the holder. For that,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in