Thingiverse
LP-E10 Canon Battery Cap with Labels
by danielbis
7
Downloads
8
Likes
1
Makes
These battery caps help protect your batteries from shorting out and help you keep them organised.
There are two caps, one says 'Full' and one 'Flat'. I printed one in blue and the other in red to help distinguish them.
I used PETG filament because it is slightly bendable, helping for a snug fit. I'm not sure how PLA would cope with it.
It took around 45-50 minutes to print at 0.1mm and 20mm/s. Faster speeds or greater layer heights may make the text less readable and my PETG tends to
There are two caps, one says 'Full' and one 'Flat'. I printed one in blue and the other in red to help distinguish them.
I used PETG filament because it is slightly bendable, helping for a snug fit. I'm not sure how PLA would cope with it.
It took around 45-50 minutes to print at 0.1mm and 20mm/s. Faster speeds or greater layer heights may make the text less readable and my PETG tends to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in