60 Degree 3 way PVC Coupler

My original filament spool holder broke - but I liked the threaded-rod and clamps I made - so I needed something that would hold a 16mm (5/8" OD) axle that my filament turns on.

This is sized for 1/2" Sched 40 PVC for the legs and 5/8" for the pivot point. In my-case it's a 3d printed threaded nut that all-thread goes into.

I may update with end-pieces if I find I need them for the bottom - rather than cutting the PVC at an angle.

I think I have this designed just right for printing - in my c