Thingiverse
Wanhao Di3 Dual Micro Swiss CR-10 Hotends Carriage
by spronkets
0
Downloads
1
Likes
0
Makes
I'm no designer and this is no masterpiece, but this is what I came up with to put two CR-10 Micro Swiss hotends on my Wanhao Di3.
If your printer doesn't do well with overhangs, you should probably print with supports so the hotends fit snuggly without cutting.
Lastly, the little clips at the end are actually for attachments. I plan on adding some pieces that will drill into the sides and hold fans and a BLTouch. I'll include these once I get a chance to making them.
WARNING: The Wanha
If your printer doesn't do well with overhangs, you should probably print with supports so the hotends fit snuggly without cutting.
Lastly, the little clips at the end are actually for attachments. I plan on adding some pieces that will drill into the sides and hold fans and a BLTouch. I'll include these once I get a chance to making them.
WARNING: The Wanha
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in