Thingiverse
Two Trees Sapphire Mount E3Dv6 Version 3
by Fvrank
85
Downloads
59
Likes
0
Makes
Version 1 with 5mm offset y-axis - Fan 30-40 mm
Version 2 Fan 30-40 mm (can bump into top belt bearing so you have to extend x-axis stopper with 2mm)
Version 3 Fan 30 mm only (+ extra z height)
Here is version 3 of the mount for E3DV6 suited for only 30mm fan in front.
Placed the hot-end 5mm to the back so no loss in Y-axis anymore and no risk bumping into the left belt bearing. extra z height and front mount. Sensor PINDA 5.2 mm will fit
Mount print with support in Cura put on Enabl
Version 2 Fan 30-40 mm (can bump into top belt bearing so you have to extend x-axis stopper with 2mm)
Version 3 Fan 30 mm only (+ extra z height)
Here is version 3 of the mount for E3DV6 suited for only 30mm fan in front.
Placed the hot-end 5mm to the back so no loss in Y-axis anymore and no risk bumping into the left belt bearing. extra z height and front mount. Sensor PINDA 5.2 mm will fit
Mount print with support in Cura put on Enabl
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in