Thingiverse
8BitDo Dogle Button/Lid
door arthur_w74
0
Downloads
0
Likes
0
Makes
PLA Printing: 8BitDo Dogle Templates
PLA Button:
Recommended Settings:
Layer Height: 0.12mm (accurate) to 0.2mm (fast).
Temperature: 190-210°C (adjust according to PLA).
Speed: 40-60mm/s to avoid vibrations.
Post-Processing: Lightly sand the sides to ensure a perfect fit.
PLA Lid:
Advantages: Adequate rigidity for protection, even at low infill (20%).
Settings:
Use 100% cooling to avoid sagging in overhead areas.
3-5mm lip for adhesion to flat parts.
Tip: If warping occurs, adjust the bed temperature (60°C) and clean with alcohol.
Final Notes:
Printed on Bamboo Lab A1 Mini
PLA vs. PETG: PLA is easier to print, but PETG offers greater impact resistance (recommended for intensive use).
PLA Button:
Recommended Settings:
Layer Height: 0.12mm (accurate) to 0.2mm (fast).
Temperature: 190-210°C (adjust according to PLA).
Speed: 40-60mm/s to avoid vibrations.
Post-Processing: Lightly sand the sides to ensure a perfect fit.
PLA Lid:
Advantages: Adequate rigidity for protection, even at low infill (20%).
Settings:
Use 100% cooling to avoid sagging in overhead areas.
3-5mm lip for adhesion to flat parts.
Tip: If warping occurs, adjust the bed temperature (60°C) and clean with alcohol.
Final Notes:
Printed on Bamboo Lab A1 Mini
PLA vs. PETG: PLA is easier to print, but PETG offers greater impact resistance (recommended for intensive use).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!