Thingiverse
Aimpoint Pro/Comp M4 Risers
von mikemillerdev
2
Downloads
0
Likes
0
Makes
Risers for an Aimpoint Pro/Comp M4.
Intended to try each height at home to find out which fits your use case, before ordering a real mount or spacer.
Not intended for range use under recoil.
Use with M5-0.8 screws, 22mm long for the 1.73", 25mm long for the 1.93" and 2.04" mounts, and 35mm for the 2.26" mount. I was unable to find any 35mm locally so I just used some zipties to get a sight picture.
You will probably have to file some of the elephant foot off of the bottom after printing to get it to fit.
Make sure to enable supports in your splicer tool.
Intended to try each height at home to find out which fits your use case, before ordering a real mount or spacer.
Not intended for range use under recoil.
Use with M5-0.8 screws, 22mm long for the 1.73", 25mm long for the 1.93" and 2.04" mounts, and 35mm for the 2.26" mount. I was unable to find any 35mm locally so I just used some zipties to get a sight picture.
You will probably have to file some of the elephant foot off of the bottom after printing to get it to fit.
Make sure to enable supports in your splicer tool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!