Thingiverse
Aimpoint Pro/Comp M4 Risers
2
Downloads
0
Likes
0
Makes
Risers for an Aimpoint Pro/Comp M4.
Intended to try each height at home to find out which fits your use case, before ordering a real mount or spacer.
Not intended for range use under recoil.
Use with M5-0.8 screws, 22mm long for the 1.73", 25mm long for the 1.93" and 2.04" mounts, and 35mm for the 2.26" mount. I was unable to find any 35mm locally so I just used some zipties to get a sight picture.
You will probably have to file some of the elephant foot off of the bottom after printing to get it to fit.
Make sure to enable supports in your splicer tool.
Intended to try each height at home to find out which fits your use case, before ordering a real mount or spacer.
Not intended for range use under recoil.
Use with M5-0.8 screws, 22mm long for the 1.73", 25mm long for the 1.93" and 2.04" mounts, and 35mm for the 2.26" mount. I was unable to find any 35mm locally so I just used some zipties to get a sight picture.
You will probably have to file some of the elephant foot off of the bottom after printing to get it to fit.
Make sure to enable supports in your splicer tool.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!