Basic TV-B-Gone case
by Liftyee
2
Downloads
2
Likes
0
Makes
A simple case for the Adafruit TV-B-Gone kit v1.2 (should work with v1.1 too, but untested)
I recommend printing the top half in translucent filament so that you can see the LED.
Optional M3 screw hole if 0.15 tolerance is too much
Remember to leave about 3/4 of the battery wires (7-9cm) so that you can assemble and use easily.
Infill percentage doesn't matter, print without raft or brim (no parts use infill).
I recommend printing the top half in translucent filament so that you can see the LED.
Optional M3 screw hole if 0.15 tolerance is too much
Remember to leave about 3/4 of the battery wires (7-9cm) so that you can assemble and use easily.
Infill percentage doesn't matter, print without raft or brim (no parts use infill).
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!