Basic TV-B-Gone case
por Liftyee
2
Descargas
2
Likes
0
Makes
A simple case for the Adafruit TV-B-Gone kit v1.2 (should work with v1.1 too, but untested)
I recommend printing the top half in translucent filament so that you can see the LED.
Optional M3 screw hole if 0.15 tolerance is too much
Remember to leave about 3/4 of the battery wires (7-9cm) so that you can assemble and use easily.
Infill percentage doesn't matter, print without raft or brim (no parts use infill).
I recommend printing the top half in translucent filament so that you can see the LED.
Optional M3 screw hole if 0.15 tolerance is too much
Remember to leave about 3/4 of the battery wires (7-9cm) so that you can assemble and use easily.
Infill percentage doesn't matter, print without raft or brim (no parts use infill).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!