Thingiverse
Blink Sync Module 2 Bracket Mount
von solutionhacker
166
Downloads
104
Likes
1
Makes
This is a simple one-piece wall bracket for the Blink Sync Module 2.
While I'm aware that there are wall brackets for the Blink on Amazon and even some designs on Thingiverse, I wanted something that took only 1 hour or less to print. So I designed this and it did the trick.
My design uses only 9 grams of filament and is 30% more eco-friendly than some other designs I've seen online. The fitting works really well with the latest Blink Sync Module 2 and USB adapter. It fits snug and the USB holes are well accounted for.
I sliced the STL in Cura and used a 30% infill with 0.2 layer height. I printed this in PLA with supports enabled.
Remember that the USB adapter should be inserted from the bottom of the part because one side of the adapter is slightly narrower than the other. Only one side can be slotted in. It's self-explanatory.
While I'm aware that there are wall brackets for the Blink on Amazon and even some designs on Thingiverse, I wanted something that took only 1 hour or less to print. So I designed this and it did the trick.
My design uses only 9 grams of filament and is 30% more eco-friendly than some other designs I've seen online. The fitting works really well with the latest Blink Sync Module 2 and USB adapter. It fits snug and the USB holes are well accounted for.
I sliced the STL in Cura and used a 30% infill with 0.2 layer height. I printed this in PLA with supports enabled.
Remember that the USB adapter should be inserted from the bottom of the part because one side of the adapter is slightly narrower than the other. Only one side can be slotted in. It's self-explanatory.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!