Block Laptop Riser

<Product Description>・This product is a laptop riser.・This product is completed by assembling three component.・Stacking component A（blocks） is required to increase the height of the laptop.・Each component A（blocks） can be angled at an angle of approximately 5 degrees.・Enjoy printing in your favorite colors.・All component can be downloaded from this page.・Product size: 215mm x 200mm x 75mm（w×d×h） <Production＞・This product was created using Blender.・Output was done using FLASHFORGE Guider2. <Notes> ・Please use this product as a laptop riser. Please refrain from using it for any other purpose.・Please be careful when handling this product, as it has a sharp tip. Especially, please keep out of reach of children.・Please note that we will not be responsible for any accidents or injuries caused by this product.・We will not be responsible for any damage to a PC, table, etc. caused by the use of this product.・The photo is for illustrative purposes only.・When importing into the slicer software, I