Thingiverse
Bridge Rectifier
von Alerat
3
Downloads
1
Likes
0
Makes
This Thing is a bridge rectifier and is intended to be printed using LCD/DLP resin printer.
The concept is to encapsulate electronic components into a hard 3D printed shell, closed with the same resin for a seemless design.
This Thing comes in two sizes.
- One suitable with Diode 2CLG30KV_20mA.
- Other suitable with Diode VG12_22.
Each requires four screws Hexa M4_16mm and matching nuts for connection.
Made with Anycubic Transparent resin and used at 20KV without problem.
The concept is to encapsulate electronic components into a hard 3D printed shell, closed with the same resin for a seemless design.
This Thing comes in two sizes.
- One suitable with Diode 2CLG30KV_20mA.
- Other suitable with Diode VG12_22.
Each requires four screws Hexa M4_16mm and matching nuts for connection.
Made with Anycubic Transparent resin and used at 20KV without problem.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
