Thingiverse
CalibrationCube
von xpix
9
Downloads
4
Likes
0
Makes
Hello Friends,
the normal xyzCalibrationCube was not enough for me, because I also wanted to test holes and threads. Here is my cube that has already served me very well in setting up my 3D printer.
The edge length is 20mm with a bevel of 1mm.
2 holes on the XY side with 10.05 and 8.05 mm diameter, take the shaft of a drill (8 and 10mm) and insert it into the hole. It should fit perfectly without wobbling. There is also an M8x1.25 thread on the Z-side. Here you should be able to screw in an appropriate screw.
the normal xyzCalibrationCube was not enough for me, because I also wanted to test holes and threads. Here is my cube that has already served me very well in setting up my 3D printer.
The edge length is 20mm with a bevel of 1mm.
2 holes on the XY side with 10.05 and 8.05 mm diameter, take the shaft of a drill (8 and 10mm) and insert it into the hole. It should fit perfectly without wobbling. There is also an M8x1.25 thread on the Z-side. Here you should be able to screw in an appropriate screw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
