Thingiverse
CalibrationCube
di xpix
9
Download
4
Likes
0
Makes
Hello Friends,
the normal xyzCalibrationCube was not enough for me, because I also wanted to test holes and threads. Here is my cube that has already served me very well in setting up my 3D printer.
The edge length is 20mm with a bevel of 1mm.
2 holes on the XY side with 10.05 and 8.05 mm diameter, take the shaft of a drill (8 and 10mm) and insert it into the hole. It should fit perfectly without wobbling. There is also an M8x1.25 thread on the Z-side. Here you should be able to screw in an appropriate screw.
the normal xyzCalibrationCube was not enough for me, because I also wanted to test holes and threads. Here is my cube that has already served me very well in setting up my 3D printer.
The edge length is 20mm with a bevel of 1mm.
2 holes on the XY side with 10.05 and 8.05 mm diameter, take the shaft of a drill (8 and 10mm) and insert it into the hole. It should fit perfectly without wobbling. There is also an M8x1.25 thread on the Z-side. Here you should be able to screw in an appropriate screw.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
