Thingiverse
case for scissors
von whiteboom
53
Downloads
53
Likes
0
Makes
Case for scissors with a latch.
The total length of the scissors is 10cm
width inside 6.5mm
of two parts, printing without supports
it is recommended to glue the lid on glue
Чехол для маникюрных ножниц с защелкой.
общая длинна ножниц 10см
внутренняя ширина 6,5мм
из двух частей, печать без поддержек
крышку рекомендуется вклеить на клей
The total length of the scissors is 10cm
width inside 6.5mm
of two parts, printing without supports
it is recommended to glue the lid on glue
Чехол для маникюрных ножниц с защелкой.
общая длинна ножниц 10см
внутренняя ширина 6,5мм
из двух частей, печать без поддержек
крышку рекомендуется вклеить на клей
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!