Thingiverse
case for scissors
por whiteboom
53
Descargas
53
Likes
0
Makes
Case for scissors with a latch.
The total length of the scissors is 10cm
width inside 6.5mm
of two parts, printing without supports
it is recommended to glue the lid on glue
Чехол для маникюрных ножниц с защелкой.
общая длинна ножниц 10см
внутренняя ширина 6,5мм
из двух частей, печать без поддержек
крышку рекомендуется вклеить на клей
The total length of the scissors is 10cm
width inside 6.5mm
of two parts, printing without supports
it is recommended to glue the lid on glue
Чехол для маникюрных ножниц с защелкой.
общая длинна ножниц 10см
внутренняя ширина 6,5мм
из двух частей, печать без поддержек
крышку рекомендуется вклеить на клей
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!