Thingiverse
changing table mobile
von ottofrangelico
0
Downloads
0
Likes
0
Makes
The mount and connectors of a changing table mobile.
My Son likes it very much that there is something dangling over the changing table.
The prints have to be completed by round woods. In my case i had a 14mm and 8mm at home and used this. If you need something else, just adjust the fusion files.
I put some holes for screws in the connector cube, but in the end the fit was so tight that i didn't need them.
My Son likes it very much that there is something dangling over the changing table.
The prints have to be completed by round woods. In my case i had a 14mm and 8mm at home and used this. If you need something else, just adjust the fusion files.
I put some holes for screws in the connector cube, but in the end the fit was so tight that i didn't need them.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!