Thingiverse
changing table mobile
door ottofrangelico
0
Downloads
0
Likes
0
Makes
The mount and connectors of a changing table mobile.
My Son likes it very much that there is something dangling over the changing table.
The prints have to be completed by round woods. In my case i had a 14mm and 8mm at home and used this. If you need something else, just adjust the fusion files.
I put some holes for screws in the connector cube, but in the end the fit was so tight that i didn't need them.
My Son likes it very much that there is something dangling over the changing table.
The prints have to be completed by round woods. In my case i had a 14mm and 8mm at home and used this. If you need something else, just adjust the fusion files.
I put some holes for screws in the connector cube, but in the end the fit was so tight that i didn't need them.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!