Customizable container for electronic elements

An improvement on the previous model of the resistor storage container( https://www.thingiverse.com/thing:6557120 ).
Now the model is customizable, you can use Customizer for specify the parameters you need for the container.
On the lid, the values ​​must already be written down manually.

Print settings:

Line width - 0.4mm;
Layer height - 0.2mm;
3 wall lines;
Printing without supports.

P.S. In the customizer the corners on the container are poorly displayed, but on the 3D model itself there are no problems with them.