Thingiverse
Tools
Model downloaden
Customizable container for electronic elements
59
Downloads
133
Likes
0
Makes
An improvement on the previous model of the resistor storage container( https://www.thingiverse.com/thing:6557120 ).
Now the model is customizable, you can use Customizer for specify the parameters you need for the container.
On the lid, the values must already be written down manually.
Print settings:
Line width - 0.4mm;
Layer height - 0.2mm;
3 wall lines;
Printing without supports.
P.S. In the customizer the corners on the container are poorly displayed, but on the 3D model itself there are no problems with them.
Now the model is customizable, you can use Customizer for specify the parameters you need for the container.
On the lid, the values must already be written down manually.
Print settings:
Line width - 0.4mm;
Layer height - 0.2mm;
3 wall lines;
Printing without supports.
P.S. In the customizer the corners on the container are poorly displayed, but on the 3D model itself there are no problems with them.
Ozamo publiceert ook op
16 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
