Slicer Discord
Dice magic trick – 3D-Druckmodell von MakerWorld MakerWorld
Hand Tools

Dice magic trick

15 Downloads
12 Likes
12 Makes
Zum Modell
This is a cube magic trick. It is fully 3d printed. Here is how to do it: Ask a partner or guest to take the dice out and choose a number 1-6 and place the dice back in the box on that side. All this is happening while you hole the box behind your back and the lid in your other hand.Turn around so the audience cannot see the box.Put the lid on the side, not on the top while the box is behind your back.Maneuver the box to the front of you without them seeing that the the lid is not on the box.Pretend that you are doing magic.Guess the numberQuickly, turn the box to face the audience without them notice that the open side was facing you.The 5th picture is a video following the cube:The 6th picture is a video from the spectator’s point of view:Note: If you have a textured plate then they can tell which side is the bottom.If the audience say that you are feeling for the dots, than tell them that if you are feeling for the dots, they would hear the cube move in the box.Boost MePlease boost
Kategorie
Hand Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Larry12345 veröffentlicht auch auf

2 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen