Slicer Discord
DROP-LOOP – Modelo 3D imprimible de GrabCAD GrabCAD
STL

DROP-LOOP

por Vener B · STL
39 Descargas
16 Likes
0 Makes
Ver Modelo
The weight of the egg will push itself forward, but instead of straight down it will be on a loop until it slows down. the revolution of the egg will start as soon as the object touch the ground. As newtons law of interaction. the impact will halt the movement of the main body, thus the egg which is movable will continue moving ( on a loop) until is stops. The egg holder has a umbrella shaped side, this will slows down the movement of the egg when its hits the ground. also it will help the egg during falling to stay at the side of the ring (thats the starting position of the egg) the issue of the center of gravity as a whole is not tested, if it will be upright in mid air. but most likely it will not be in the center of the ring. thats why the tail is closer to the egg ( which adds the total weight)
Categoría
STL
Fuente
GrabCAD
Publicado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL, STEP
Material
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección