Slicer Discord
DROP-LOOP – 3D-printbaar model van GrabCAD GrabCAD
STL

DROP-LOOP

door Vener B · STL
39 Downloads
16 Likes
0 Makes
Model downloaden
The weight of the egg will push itself forward, but instead of straight down it will be on a loop until it slows down. the revolution of the egg will start as soon as the object touch the ground. As newtons law of interaction. the impact will halt the movement of the main body, thus the egg which is movable will continue moving ( on a loop) until is stops. The egg holder has a umbrella shaped side, this will slows down the movement of the egg when its hits the ground. also it will help the egg during falling to stay at the side of the ring (thats the starting position of the egg) the issue of the center of gravity as a whole is not tested, if it will be upright in mid air. but most likely it will not be in the center of the ring. thats why the tail is closer to the egg ( which adds the total weight)
Categorie
STL
Bron
GrabCAD
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL, STEP
Materiaal
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie