Slicer Discord
DROP-LOOP – 3D-Druckmodell von GrabCAD GrabCAD
STL

DROP-LOOP

von Vener B · STL
39 Downloads
16 Likes
0 Makes
Zum Modell
The weight of the egg will push itself forward, but instead of straight down it will be on a loop until it slows down. the revolution of the egg will start as soon as the object touch the ground. As newtons law of interaction. the impact will halt the movement of the main body, thus the egg which is movable will continue moving ( on a loop) until is stops. The egg holder has a umbrella shaped side, this will slows down the movement of the egg when its hits the ground. also it will help the egg during falling to stay at the side of the ring (thats the starting position of the egg) the issue of the center of gravity as a whole is not tested, if it will be upright in mid air. but most likely it will not be in the center of the ring. thats why the tail is closer to the egg ( which adds the total weight)
Kategorie
STL
Quelle
GrabCAD
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL, STEP
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen