Thingiverse
Etherow code
von Arkmana
0
Downloads
1
Likes
0
Makes
This is Etherow's code from Tsutomu Nihei's Aposimz Manga.
It is 1:1 based on the measurements from the replica that was a give away with Vol 2 in japan.
Probably best to print in red filament, but if you do paint it (like i did) you may have to sand the connectors to make room.
Disclaimer: Please check your code compatibility before opening!
It is 1:1 based on the measurements from the replica that was a give away with Vol 2 in japan.
Probably best to print in red filament, but if you do paint it (like i did) you may have to sand the connectors to make room.
Disclaimer: Please check your code compatibility before opening!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!