Thingiverse
Etherow code
door Arkmana
0
Downloads
1
Likes
0
Makes
This is Etherow's code from Tsutomu Nihei's Aposimz Manga.
It is 1:1 based on the measurements from the replica that was a give away with Vol 2 in japan.
Probably best to print in red filament, but if you do paint it (like i did) you may have to sand the connectors to make room.
Disclaimer: Please check your code compatibility before opening!
It is 1:1 based on the measurements from the replica that was a give away with Vol 2 in japan.
Probably best to print in red filament, but if you do paint it (like i did) you may have to sand the connectors to make room.
Disclaimer: Please check your code compatibility before opening!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!