Thingiverse
Fence Post Insert Cap
von Eugenius19
1
Downloads
2
Likes
0
Makes
This is an internal fence post insert cap (end plug) designed for square fence posts with an inner width of approximately 53.2 mm.
Print Settings:
Layer height: 0.2 mm
Infill: 20%
Supports: Not required
Filament: I used PLA, but PETG should work better in the sun
Print Settings:
Layer height: 0.2 mm
Infill: 20%
Supports: Not required
Filament: I used PLA, but PETG should work better in the sun
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
