Thingiverse
Fence Post Insert Cap
door Eugenius19
1
Downloads
2
Likes
0
Makes
This is an internal fence post insert cap (end plug) designed for square fence posts with an inner width of approximately 53.2 mm.
Print Settings:
Layer height: 0.2 mm
Infill: 20%
Supports: Not required
Filament: I used PLA, but PETG should work better in the sun
Print Settings:
Layer height: 0.2 mm
Infill: 20%
Supports: Not required
Filament: I used PLA, but PETG should work better in the sun
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
