Fingerboard deck drying rack

This is a drying / curing rack for fingerboard makers. It is not meant to be a completed board display rack (shelves are purposesly too close together).

It can hold 10 decks on each side.

I printed the racks flat on my printer bed, no supports. 3 walls and 15% infill.

You can cut sections of bamboo shishkabob sticks or round toothpics for each shelf. I would cut them to 47mm long as 10mm fits inside the rack. Use a drop of CA glue to secure the sticks in the holes.

I cut sections of 1/2" MDF for the bases, they measure 4.5" x 4.5". I used 6x1/2" screws to screw the rack into the MDF. Very secure.