Thingiverse
Fingerboard deck drying rack
door PandaProps
2
Downloads
7
Likes
0
Makes
This is a drying / curing rack for fingerboard makers. It is not meant to be a completed board display rack (shelves are purposesly too close together).
It can hold 10 decks on each side.
I printed the racks flat on my printer bed, no supports. 3 walls and 15% infill.
You can cut sections of bamboo shishkabob sticks or round toothpics for each shelf. I would cut them to 47mm long as 10mm fits inside the rack. Use a drop of CA glue to secure the sticks in the holes.
I cut sections of 1/2" MDF for the bases, they measure 4.5" x 4.5". I used 6x1/2" screws to screw the rack into the MDF. Very secure.
It can hold 10 decks on each side.
I printed the racks flat on my printer bed, no supports. 3 walls and 15% infill.
You can cut sections of bamboo shishkabob sticks or round toothpics for each shelf. I would cut them to 47mm long as 10mm fits inside the rack. Use a drop of CA glue to secure the sticks in the holes.
I cut sections of 1/2" MDF for the bases, they measure 4.5" x 4.5". I used 6x1/2" screws to screw the rack into the MDF. Very secure.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
