Thingiverse
First Layer Calibration Test
door TaylorsMake
63
Downloads
31
Likes
0
Makes
This is a Live z height test to help get an accurate first layer height tuned in.
The model steps up from 0.20 mm in 0.20 mm increments up to 1 mm in height.
Make sure to read the print instructions and understand before trying it.
The model steps up from 0.20 mm in 0.20 mm increments up to 1 mm in height.
Make sure to read the print instructions and understand before trying it.
TaylorsMake publiceert ook op
16 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
