Thingiverse
Flame - Large
door Greenfieldaddy
0
Downloads
6
Likes
0
Makes
7/1/2026
Flame - Large
This is my first attempt at making a flame. The purpose was to make a "fireball" for the dragon prop. However, this prop can also be turned 90 deg and look like a flame!
It is made for typical 12mm bullet pixels. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5".
It is composed of 48 separate pieces. (there are 2 test pieces used to test print and don't attach to the flame).
Most pieces are 6mm thick with a 2mm thick raised edge that is 10mm high. I believe this will be plenty strong and use less material than my previous attempt
using 10mm thickness through out.
Its approximate size is 836mm wide x 1259mm high (33.5in x 50.3in).
It holds 191 bullet pixels. (yes, I know not quite 200!)
Printer:
All the parts should be able to be printed on a minimum bed size of 220x220mm.
Assembly:
Please use the two Assembly pictures to see how to put it together. The picture with "Assembly" in the name sho
Flame - Large
This is my first attempt at making a flame. The purpose was to make a "fireball" for the dragon prop. However, this prop can also be turned 90 deg and look like a flame!
It is made for typical 12mm bullet pixels. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5".
It is composed of 48 separate pieces. (there are 2 test pieces used to test print and don't attach to the flame).
Most pieces are 6mm thick with a 2mm thick raised edge that is 10mm high. I believe this will be plenty strong and use less material than my previous attempt
using 10mm thickness through out.
Its approximate size is 836mm wide x 1259mm high (33.5in x 50.3in).
It holds 191 bullet pixels. (yes, I know not quite 200!)
Printer:
All the parts should be able to be printed on a minimum bed size of 220x220mm.
Assembly:
Please use the two Assembly pictures to see how to put it together. The picture with "Assembly" in the name sho
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
