Thingiverse
Hard Drive Stackable Mounts
von Penwinn
31
Downloads
19
Likes
0
Makes
This comes in 3 parts depending on configuration needs. All configurations allow air flow for cooling.
The Base Mount can hold a HDD that can be easily swapped or a permanent SSD installed at the bottom. Base Mounts can be stacked and held together (I used 3M x 12mm screws and nuts to minimize vibrations).
The Middle Mount can only hold a SSD but can allow rapid swap out. It also leaves enough space to install a SSD at the bottom.
The Top Mount can only hold a permanent SSD.
Recommend purchasing thumbscrews 6-32 x 5 for securing drives.
The Base Mount can hold a HDD that can be easily swapped or a permanent SSD installed at the bottom. Base Mounts can be stacked and held together (I used 3M x 12mm screws and nuts to minimize vibrations).
The Middle Mount can only hold a SSD but can allow rapid swap out. It also leaves enough space to install a SSD at the bottom.
The Top Mount can only hold a permanent SSD.
Recommend purchasing thumbscrews 6-32 x 5 for securing drives.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!