Thingiverse
Hypercube Threaded Rod Support
von andrewhughes86
51
Downloads
33
Likes
0
Makes
Hypercube Threaded Rod Support
This only works if your threaded rod reaches the top 2020 rail. You will need a 8mm bearing to press in.
Printed with my Hypercube: .1 layer height and 50% infill. Should be fine with .2 or better.
This only works if your threaded rod reaches the top 2020 rail. You will need a 8mm bearing to press in.
Printed with my Hypercube: .1 layer height and 50% infill. Should be fine with .2 or better.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
