Thingiverse
Hypercube Threaded Rod Support
51
Downloads
33
Likes
0
Makes
Hypercube Threaded Rod Support
This only works if your threaded rod reaches the top 2020 rail. You will need a 8mm bearing to press in.
Printed with my Hypercube: .1 layer height and 50% infill. Should be fine with .2 or better.
This only works if your threaded rod reaches the top 2020 rail. You will need a 8mm bearing to press in.
Printed with my Hypercube: .1 layer height and 50% infill. Should be fine with .2 or better.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
