Thingiverse

Hyperlite FlowRide Stack Guard

by Airmaxx23

11 Downloads

12 Likes

0 Makes

These are stack guards for the HyperLite FlowRide. I'm using a BetaFlight F7 flight controller and the ribbon cable connecting the F7 gyro is in a bad location on the side of the board next to the USB port. It is intended to protect the ribbon cable but can also be used if you're running your motors/props in reverse rotation to keep the stack clean.

There are 2 versions available:

FlowRide_Guards are used with my VTx and antenna tube mount found here: https://www.thingiverse.com/thing:2986710

FlowRide_Guards_Full are full height at both standoffs and used without any rear mount.

flight controller flosstyle flowride guard hyperlite Protection protector stack flight controller flosstyle flowride guard hyperlite Protection protector stack

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Software

Cura, PrusaSlicer, or similar

No ratings yet

No comments yet – be the first!

Hyperlite FlowRide Stack Guard

Add to Collection