Thingiverse

Hyperlite FlowRide Stack Guard

von Airmaxx23

11 Downloads

12 Likes

0 Makes

These are stack guards for the HyperLite FlowRide. I'm using a BetaFlight F7 flight controller and the ribbon cable connecting the F7 gyro is in a bad location on the side of the board next to the USB port. It is intended to protect the ribbon cable but can also be used if you're running your motors/props in reverse rotation to keep the stack clean.

There are 2 versions available:

FlowRide_Guards are used with my VTx and antenna tube mount found here: https://www.thingiverse.com/thing:2986710

FlowRide_Guards_Full are full height at both standoffs and used without any rear mount.

flight controller flosstyle flowride guard hyperlite Protection protector stack flight controller flosstyle flowride guard hyperlite Protection protector stack

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Hyperlite FlowRide Stack Guard

Zur Sammlung hinzufügen