Thingiverse
Hyperlite FlowRide Stack Guard
door Airmaxx23
11
Downloads
12
Likes
0
Makes
These are stack guards for the HyperLite FlowRide. I'm using a BetaFlight F7 flight controller and the ribbon cable connecting the F7 gyro is in a bad location on the side of the board next to the USB port. It is intended to protect the ribbon cable but can also be used if you're running your motors/props in reverse rotation to keep the stack clean.
There are 2 versions available:
FlowRide_Guards are used with my VTx and antenna tube mount found here: https://www.thingiverse.com/thing:2986710
FlowRide_Guards_Full are full height at both standoffs and used without any rear mount.
There are 2 versions available:
FlowRide_Guards are used with my VTx and antenna tube mount found here: https://www.thingiverse.com/thing:2986710
FlowRide_Guards_Full are full height at both standoffs and used without any rear mount.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!