Thingiverse
Joint-Test
von hullekulleka
9
Downloads
10
Likes
0
Makes
A Simple Joint test with 5 margins which vary from 0,1mm to 0,5mm
Best to be printed at 0,1mm Layer height, no supports needed.
If you print this with Bed-Adhesion, youn can simply break the inner parts by moving the Joint-Elements with slightly more force.
100% Infill recommendet due to stability.
Best to be printed at 0,1mm Layer height, no supports needed.
If you print this with Bed-Adhesion, youn can simply break the inner parts by moving the Joint-Elements with slightly more force.
100% Infill recommendet due to stability.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
