Thingiverse
Joint-Test
door hullekulleka
9
Downloads
10
Likes
0
Makes
A Simple Joint test with 5 margins which vary from 0,1mm to 0,5mm
Best to be printed at 0,1mm Layer height, no supports needed.
If you print this with Bed-Adhesion, youn can simply break the inner parts by moving the Joint-Elements with slightly more force.
100% Infill recommendet due to stability.
Best to be printed at 0,1mm Layer height, no supports needed.
If you print this with Bed-Adhesion, youn can simply break the inner parts by moving the Joint-Elements with slightly more force.
100% Infill recommendet due to stability.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
