Thingiverse
Karearea Shell Prototype
von MauiToast
4
Downloads
6
Likes
0
Makes
Work In Progress, Needs support while printing. Fits a micro camera at 30degrees, Crossfire tx and immortal antenna holder. Also fits a tbs unify vtx. Some fitting is still required.
Enjoy and feel free to share feed back
V10 #1- First!!
V11 #2- Smoothed inner wings to remove need for some support. Flared the wings out just a bit more for motor wire clearance. Filleted a few edges to increase strength. Increased the supports in the rear of the frame.
Enjoy and feel free to share feed back
V10 #1- First!!
V11 #2- Smoothed inner wings to remove need for some support. Flared the wings out just a bit more for motor wire clearance. Filleted a few edges to increase strength. Increased the supports in the rear of the frame.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!