Thingiverse
Karearea Shell Prototype
by MauiToast
4
Downloads
6
Likes
0
Makes
Work In Progress, Needs support while printing. Fits a micro camera at 30degrees, Crossfire tx and immortal antenna holder. Also fits a tbs unify vtx. Some fitting is still required.
Enjoy and feel free to share feed back
V10 #1- First!!
V11 #2- Smoothed inner wings to remove need for some support. Flared the wings out just a bit more for motor wire clearance. Filleted a few edges to increase strength. Increased the supports in the rear of the frame.
Enjoy and feel free to share feed back
V10 #1- First!!
V11 #2- Smoothed inner wings to remove need for some support. Flared the wings out just a bit more for motor wire clearance. Filleted a few edges to increase strength. Increased the supports in the rear of the frame.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!