Thingiverse
Knotmaker
door MWa2019
0
Downloads
2
Likes
0
Makes
This is for practicing to tie (sailors) knots and a cleat.
Print both halves with support depending on your printers capability to print overhangs. The cleat does not need any support when printed flat. 50 to 60 % infill should be enough.
After printing, it might need some post-printing work in terms of cleaning and maybe some grinding, although it should fit nicely without.
Glue both halves together with the cleat in the middle but be aware that the cleat should be moveable for proper function.
Print both halves with support depending on your printers capability to print overhangs. The cleat does not need any support when printed flat. 50 to 60 % infill should be enough.
After printing, it might need some post-printing work in terms of cleaning and maybe some grinding, although it should fit nicely without.
Glue both halves together with the cleat in the middle but be aware that the cleat should be moveable for proper function.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
