MakerWorld
Office
Model downloaden
Laptop riser (closable notebook) adjustable angle
123
Downloads
40
Likes
91
Makes
I found a monitor riser where you can also close your notebook but it had an fixed angle so it would't work with different notebooks. Because of that i created this one where you can turn the angle so it should fit for every notebook! (your notebook shouldn't be thicker then 2,5cm, if so tell me and i will upload a longer model). Print information:You can just use the print profile and print the model. When the print is done you can't instantly rotate the handle. You need to try turning it in both directions over and over (basically wiggeling) until it releases. After it is released you can easily turn it but it does not turn by its own! Hope you like the model but still be careful when closing your notebook, you shouldn't aply to much pressure!Boost MeI would be happy about every boost! :D
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
