Learn Java for FTC Programming Board

This is a 3d-printed programming board I designed as a companion to the book [Learn Java for FTC by Alan Smith](https://www.reddit.com/r/FTC/comments/qbhwkc/free_pdf_of_book_learn_java_for_ftc/). This allows a control hub, motor, touch sensor, color sensor, servo, and potentiometer to all be mounted to the board and wired up. The FTC team I mentor (#26037 Cyber Tigers) uses this programming board to learn Java along with the book.

The programing board design can accommodate either a REV motor or a GoBilda motor. The programming board is the same in either scenario, but the additional parts you print will be different. So, print the programming board, and then print the corresponding cover (the REV cover is a little wider because the motor shaft sticks out more), front motor mount, rear motor support, rear motor clamp, and motor wheel for the type of motor you're going with.

Suggest the following print settings:
* Programming Board - 0.20mm layer height, supports everywhere, 15% infil