LED strap switch bracket

This is my take on a bracket for UNITAK3D LED strap switch.
I didn't like the look and the fit of the bracket, which was referenced from the LED strap's instructions:
https://www.thingiverse.com/thing:4884048
The switch was not held tight, and was freely moving every time I was operating it.

Features:
- less bulky, nicer looking
- less material
- faster to print,
- holds the switch nice and tight
- the holes are offset, and the bracket stays flush with the printer's face
- less prone to break - clips were reduced to only one, and it was additionally reinforced.