Thingiverse
LED strap switch bracket
door krumk
13
Downloads
5
Likes
0
Makes
This is my take on a bracket for UNITAK3D LED strap switch.
I didn't like the look and the fit of the bracket, which was referenced from the LED strap's instructions:
https://www.thingiverse.com/thing:4884048
The switch was not held tight, and was freely moving every time I was operating it.
Features:
- less bulky, nicer looking
- less material
- faster to print,
- holds the switch nice and tight
- the holes are offset, and the bracket stays flush with the printer's face
- less prone to break - clips were reduced to only one, and it was additionally reinforced.
I didn't like the look and the fit of the bracket, which was referenced from the LED strap's instructions:
https://www.thingiverse.com/thing:4884048
The switch was not held tight, and was freely moving every time I was operating it.
Features:
- less bulky, nicer looking
- less material
- faster to print,
- holds the switch nice and tight
- the holes are offset, and the bracket stays flush with the printer's face
- less prone to break - clips were reduced to only one, and it was additionally reinforced.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!