Thingiverse
Leveling Square
von nuxnbolts
1
Downloads
0
Likes
0
Makes
Using less material to level the bed.
1. Open file in cura
2. Adjust to the dimensions of the bed you wish to test
3. Leave infill at defaults
4. Print with adhesion - this increases the number of lines around the hollow box to use.
Created this to avoid using too much material when checking on bed level.
1. Open file in cura
2. Adjust to the dimensions of the bed you wish to test
3. Leave infill at defaults
4. Print with adhesion - this increases the number of lines around the hollow box to use.
Created this to avoid using too much material when checking on bed level.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!