Thingiverse
Leveling Square
door nuxnbolts
1
Downloads
0
Likes
0
Makes
Using less material to level the bed.
1. Open file in cura
2. Adjust to the dimensions of the bed you wish to test
3. Leave infill at defaults
4. Print with adhesion - this increases the number of lines around the hollow box to use.
Created this to avoid using too much material when checking on bed level.
1. Open file in cura
2. Adjust to the dimensions of the bed you wish to test
3. Leave infill at defaults
4. Print with adhesion - this increases the number of lines around the hollow box to use.
Created this to avoid using too much material when checking on bed level.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!